Ethernet Settings - Grandstream Networks GSC3516 User Manual

Group
Network Settings Page Definitions

Ethernet Settings

If IPv4 is selected, the device will be using IPv4 addressing, otherwise, it will be using IPv6 addressing.
Internet Protocol
The default is Prefer IPv4.
Configures whether to set up different networks for the phone data and the call. If set to "Yes", you
Different
need to configure the data network and VoIP network respectively.
Networks for Data
and VoIP Calls
Note: Reboot is required to take effect.
IPv4
Allows users to configure the appropriate network settings on the device. Users could select "DHCP",
"Static IP" or "PPPoE".
DHCP: Obtain the IP address via one DHCP server in the LAN. All domain values about static
IP/PPPoE are unavailable (although some domain values have been saved in the flash.)
PPPoE: Configures PPPoE account/password. Obtain the IP address from the PPPoE server via
IPv4 Address Type
dialing. (When "Different Networks for Data and VoIP Calls" is set to Yes; it will be available for
"Network Configuration of Data" only).
Static IP: Manually configures IP Address, Subnet Mask, Default Router's IP Address, DNS Server
1, and DNS Server 2.
By default, it is set to "DHCP".
DHCP Option 132 defines VLAN ID and DHCP Option 133 defines priority tag ID.
it supports DHCP VLAN override via DHCP Option 132 and DHCP Option 133, or encapsulated DHCP
option 132 and DHCP option 133 in DHCP option 43.
Users could select "Disable", "DHCP Option 132 and DHCP Option 133", or "Encapsulated in
DHCP Option 43".
DHCP VLAN
When set to "DHCP Option 132 and DHCP Option 133", the device will get DHCP Option 132
Override
as VLAN ID and get DHCP Option 133 as VLAN priority, from the DHCP server directly.
When set to "Encapsulated in DHCP Option 43", the device will get VLAN ID and VLAN priority
value from the DHCP Option 43 which has DHCP Option 132 and DHCP Option 133
encapsulated. In this case, please make sure the option "Allow DHCP Option 43 and Option 66 to
Override Server" is enabled under web UI �� Maintenance �� Upgrade.
By default, it is set to "Disabled"
Host name Sets the name of the client in the DHCP request. It is optional but may be required by some Internet
(Option 12) Service Providers.
paging calls if it has the same priority. If device is in an active SIP call, device will accept paging and
hang up the SIP call.
Configures paging group. Users can configure whether to use the group to accept and join group, and
its label. Only available and joined group will be displayed in paging group list. If users need receive
paging, "Subscribe" must be enabled for this group.
Multicast/Group Paging