Switching On/Off; Operation; Mounting The Compressed Air Hose; Working Instructions - Parkside PVKO 50 A1 Translation Of The Original Instructions

GB IE
4. Press the hubcap (16) onto the wheel
(11).
5. Repeat steps 1-4 for the remaining
wheels.

Switching on/off

1. To switch the device on, move the On/
Off switch (6) to position "I".
2. To switch the device off, move the On/
Off switch (6) to position "0".

Operation

Mounting the
compressed air hose
1. Press the compressed air hose (14) into
one of the two quick connectors (13).
The compressed air hose (14) locks into
place.
Removing the compressed air hose
2. Press the coupling ring on the quick
connector (13) towards the device. The
compressed air hose (14) springs out of
the quick connector (13).
3. Press the compressed air tool into the
quick connector on the compressed air
hose.

Working instructions

Adjusting the
compressed air
The set pressure can be released from the
quick connectors (13). This pressure can
be adjusted via the pressure regulator (4)
and can be read on the manometer (set
pressure) (5).
1. To increase, turn the pressure regulator
(4) clockwise.
2. To decrease, turn the pressure regulator
(4) anti-clockwise.
20

Cleaning and servicing

Before carrying out work on
the device, switch it off and
unplug the mains plug.
You should have any repair and
maintenance work that is not de-
scribed in these instructions carried
out by our Service Centre. Only use
original parts.
Perform the following maintenance and
cleaning work regularly. This will guaran-
tee long and reliable use.
• Always keep the ventilation slits on the
device housing unobstructed otherwise
the device will overheat.
Cleaning the air filter
Never run the device without an air
filter. Dust and dirt may otherwise
enter the motor and cause damage.
Remove dust and dirt from the air filter (1a)
approx. every 300 operating hours to en-
sure proper functioning of the device.
1. Remove the air filter cover (1).
2. Remove the air filter (1a).
3. Tap out the air filter (1a).
4. Clean the air filter (1a) and the air filter
cover (1) with a little compressed air
(approx. 3 bar).
5. Reverse the sequence to remount the air
filter (1a) and the air filter cover (1).
Draining the
condensation water
Empty condensation water from the pres-
sure vessel (10) after every use.