Table of Contents
Advertisement
Figure 6.10 (Generic Fireplace Shown) Attach the fi rst
vent section (it will snap into place). Slide the insulation
gasket (shipped in the manual bag) onto the vent section,
up against the appliance and over the tabs.
B. Securing and Leveling the Appliance
WARNING! Risk of Fire! Prevent contact with:
• Sagging or loose insulation
• Insulation backing or plastic
• Framing and other combustible materials
Block openings into the chase to prevent entry of blown-
in insulation. Make sure insulation and other materials
are secured.
DO NOT notch the framing around the appliance
standoffs.
Failure to maintain air space clearance could cause
overheating and fi re.
The diagram shows how to properly square and position,
and secure the appliance. See Figures 6.11 and 6.12.
Nailing tabs are provided to secure the appliance to the
framing members.
• Bend out nailing tabs on each side.
• Place the appliance into position.
• Keep nailing tabs fl ush with the framing.
• Level the appliance from side to side and front to back.
• Shim the appliance as necessary. It is acceptable to use
wood shims underneath the appliance.
• Secure the appliance to the framing by using nails or
screws through the nailing tabs.
• Optional: Secure the appliance to the fl oor by inserting
two screws through the pilot holes at the bottom of the
appliance.
Majestic • DBDV36PLATIN, DBDV36PLATIL, DBDV42PLATIN, DBDV42PLATIL Installation Manual • 2454-980 Rev. B • 5/16
A
Note: Diagonal dimensions (A) and (B) must be within
1/4 inch of each other.
Figure 6.11 Positioning the Appliance Squarely
NAILING TABS
(BOTH SIDES)
PILOT HOLES
Figure 6.12 Proper Positioning and Securing of an Appliance
C. Non-Combustible Material Installation
The factory supplied non-combustible board spans the
distance from the top of the fi replace to the center of the
framing header. This board must be used. See Figure 6.13
HEADER
HEADER
Figure 6.13 Non-combustible Board
B
37
Advertisement
Table of Contents
