Installing A Ps/2 Serial Port Adapter - Dell Optiflex 740 User Manual

1 PCI Express x16 DVI-card
4 lever
7 PCI Express x16 card connector
7. If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the computer. The brackets also keep dust
and dirt out of your computer.
8. Before you close the card retention mechanism, ensure that:
The tops of all cards and filler brackets are flush with the alignment bar.
l
The notch in the top of the card or filler bracket fits around the alignment guide.
l
9. Secure any remaining card(s) by closing the card retention latch and snapping it into place.
NOTICE: Do not route card cables over the cards. Cables routed over the cards can prevent the computer cover from closing properly or cause damage
to the equipment.
10. Replace the computer cover (see
11. Uninstall the card's driver. See the documentation that came with the card for instructions.
12. If you removed a sound card:
a. Enter system setup, select Integrated Audio from the Onboard Devices group, and change the setting to On (see
b. Connect external audio devices to the audio connectors on the back panel of the computer.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
13. If you removed a network-adapter card connector:
a. Enter system setup, select Integrated NIC from the Onboard Devices group, and change the setting to On (see
b. Connect the network cable to the integrated network connector on the back panel of the computer.
PS/2 Serial Port Adapters
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.

Installing a PS/2 Serial Port Adapter

1. Follow the procedures in Before You
2. Gently push the release tab on the card retention latch from the inside to pivot the latch open. The latch will remain in the open position.
2 removal pull tab 3 DVI-card connector
5 securing slot 6 securing tab
Replacing the Computer Cover).
Begin.
System Setup).
System Setup).