Countax B MK4 Series Operator's Manual page 20

Deck Height Indicator Icons
The dash display houses a set of icons that make up
the deck height indicator (fig. 20). A lit LED shows
the current deck height. Operate the deck lift handle
(fig. 21) to change the deck height. The LED display
will change to show the new deck position. There are
nine deck height positions. Position 9 offers the
longest cut , while position 1 offers the shortest.
To help prevent grass scalping start with a longer cut.
Move the deck to a lower position on second trim to
achieve desired finish.
Digital Display Clock
The clock display has three functions.
Primary function (fig. 22) - During normal use the
display indicates the current time in digital format.
Secondary function (fig. 23) - In secondary mode
the clock displays engine rotational output in terms
of revolutions per minute (RPM). The RPM level is
displayed briefly at startup before the display
switches to clock mode. The display also switches
from clock mode briefly if engine output jumps when
throttle is increased.
Setting the clock - The clock can be reset using the
two hidden touch pads situated either side of the
clock display (fig. 22).
To reset the clock
1 - press and hold touch pad 1 until the two
circular digits begin to double flash.
2 - Press hidden touch pad 1 once to change the
hour to the next sequential digit. Keep pressing
the pad to cycle to the desired number.
3 - Press hidden touch pad 2 once to change the
minute to the next sequential digit. Keep pressing
the pad to cycle to the desired number.
The clock will automatically leave edit mode when
left for a few seconds. The two circular digits will
revert back to single flash to signal the process is at
an end.
Service intervals
The clock will automatically display Ins 1, Ins 2 and
Ser at set intervals during the life of the tractor.
Ins 1 - Displayed at 20 hours total run time. At
notification thoroughly visually inspect the condition
of the tractor.
Ins 2 - Displayed at 50 hours total run time. At
notification thoroughly visually inspect the condition
of the tractor.
Dashboard Display and Controls
(fig. 20 & 21)
(fig. 22 & 23)
Deck Height Indicator
Clock mode (example figures only)
Hidden touch pad 1
RPM mode (example figures only)
Ser - Displayed at 100 hours total run time. When this
notification displays the tractor has completed 100 hours
service. This unit requires full inspection and service by
your nearest approved dealer.
Clearing inspection notes
To clear Ins 1 and Ins 2 notifications;
• Press and hold touch pad 1 until Clrd is displayed.
To clear Ser notification;
• Ser notifications must only be cleared by an approved
dealer after the tractor is fully serviced.
See page 46 for service checklist information.
Page 20
Deck lift handle
Hidden touch pad 2
fig. 20
fig. 21
fig. 22
fig. 23