Installing A Riser Card - Supermicro A+ Server AS-2015HS-TNR User Manual

Installing a Riser Card

Before following the procedure below to install expansion cards, first turn off and remove
power from the system as described in
in Section 3.2.
Installing a Riser Card
1. Open any clips next to the slots and remove the PCI shield.
2. Install the riser card to the riser bracket, if necessary.
3. Install one or two expansion cards into the riser card.
4. Insert the riser card bracket with the expansion cards into the chassis rear and connect
cables.
5. Close any opened clips to secure the riser card bracket.
Chapter 3: Maintenance and Component Installation
Section 3.1
Figure 3-16. Installing a Riser Bracket
51
then remove the top cover as described