Table of Contents
Advertisement
c. Place the new storage drive with the bracket into the storage drive bay as shown. Press the two tabs
on the bracket downward and then push the storage drive inward until it snaps into position.
Figure 57. Installing the storage drive
d. Connect the signal cable and power cable to the new storage drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 155.
Storage drive cage
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
Some computers come with a storage drive cage for installing or replacing a 2.5-inch storage drive.
To remove or install a 2.5-inch storage drive in the storage drive cage, do the following:
1. Prepare your computer. See "Preparing your computer" on page 92.
2. Locate the storage drive cage. See "Internal storage drives" on page 38.
3. To remove the storage drive in storage drive cage, do the following:
a. Disconnect the signal cable and the power cable from the storage drive.
122
P330 Hardware Maintenance Manual
Advertisement
Table of Contents
