Table of Contents
Advertisement
5. To install the new Wi-Fi card, do the following:
a. If necessary, install the plastic holder first. Align the four tabs on the rear of the plastic holder with the
corresponding holes in the chassis. Then, slide the plastic holder toward the system board until it
snaps into position.
Figure 95. Installing the plastic holder
b. If necessary, locate the appropriate hole in the plastic holder to install the retaining latch. Align the
a
pin
with the hole
into position.
Figure 96. Installing the plastic holder
b
in the plastic holder. Then, press the retaining latch downward until it snaps
.
Chapter 9
Hardware removal and installation
143
Advertisement
Table of Contents
