Advertisement
0.08 mm to 1.0 mm (28 AWG to 18 AWG) copper conductor wire with 7 mm
■
(0.28 in.) of insulation stripped from the end
Flathead screwdriver with a 2.3 mm x 1.0 mm (0.09 in. x 0.04 in.) blade,
■
included with the NI-9206
What to Do
Complete the following steps to connect wires to the spring-terminal connector.
1
1. Insert the screwdriver into a spring clamp activation slot to open the
corresponding connector terminal.
2. Press a wire into the open connector terminal.
3. Remove the screwdriver from the activation slot to clamp the wire into place.
High-Vibration Application Connections
If your application is subject to high vibration, NI recommends that you use the
cRIO-9941 backshell kit to protect connections to the NI-9206.
8
ni.com
2
3
© 2023 National Instruments Corporation.
NI-9206 Getting Started
Advertisement
