Transferring A Finalized Configuration - Siemens SIMATIC RF1000 Configuration Manual

Result: The configuration is transferred to the card. You receive a corresponding message as
soon as the transfer is complete. You can then remove the card from the reader and transfer
the configuration to other readers using the configuration card.
We recommend that you clearly label the configuration card, for example with the project
name incl. version ID as this is displayed after successful creation of the configuration card
(see graphic below). This will facilitate identification and assignment of the configuration
card later. Note that it will no longer be possible later to read out the project name and
version ID from the configuration card.
Figure 6-7
Note
Creating a configuration card using the Uploader
Alternatively, you can create a configuration card using the Uploader ("bf2uploader.exe") and a
configuration file in "*.bec2" file format.
6.6

Transferring a finalized configuration

The following options are available to you for transferring a finalized configuration to a reader:
• Using the Uploader
For RF1000
• Using the configuration card and the demo application
For RF1000
• Using the WBM
For RF1100
These alternative methods are described below.
SIMATIC RF1000, RF1100
Configuration Manual, 08/2023, C79000-G8976-C647-03
Example of configuration card labeling
Creating and transferring a configuration
6.6 Transferring a finalized configuration
31