Advertisement
Device Installation/ 设备安装
D. Pole-mounted Installation/ 抱装
Pole-mounted installation with or without a junction box is almost the same. The difference is that if a
junction box is used, you need to install the junction box on the bracket first. For details about how to install
the junction box, see Beam-mounted Installation (With Junction Box).
抱装（带接线盒）场景与抱装场景的安装方法类似，区别点在于抱装（带接线盒）需要先将接线盒安装到支架上。接线
盒的详细安装方法参见横臂（带接线盒）。
Thread the camera pigtails through the center of the mounting bracket, and connect the external cabling.
1
Insulate and waterproof the connections (see Cable Connections), fix the pigtails in place, and use the M4
screws to fasten the camera to the mounting bracket using the number 5 holes.
将摄像机尾线穿过柱装支架中心圆孔， 将线缆与尾线连接， 对线缆进行绝缘和防水处理 （参见 "连接线缆" ） ， 并固定尾线。
选择编号为 5 的螺口，拧紧 M4 螺钉。
Loosen the three hex socket bolts and adjust the camera to the required angle. Then re-tighten the screws,
3
and adjust the position of the sunshield.
拧松支架的 3 个内六角螺钉，调整摄像机监控角度至所需位置，再拧紧内六角螺钉。调整好遮阳板位置。
NOTE/ 说明
After adjusting the angle of the camera, if you are unable to automatically or manually bring the image
into focus, use the web interface to log in to the IPC, and click the
the left side of the page to reset the lens.
调整完毕后，在自动对焦或者手动聚焦后图像仍然模糊（由镜头失步引起的虚焦），请登录Web页面，在预览界
面，单击页面云台控制面板的复位镜头
icon on the PTZ control panel on
。
Open up the three hose clamps and thread them through the installation holes on the mounting bracket.
2
Then use the hose clamps to affix mounting bracket to the pole. 将 3 个喉箍拧开，穿过抱装支架的安装孔。将喉
箍环绕在立杆上，拧紧喉箍，将抱装支架固定在立杆上。
CAUTION/ 注意
Make sure the cable outlet (marked with BOTTOM) faces downwards or water may enter the camera and damage
the device.
摄像机底座写有BOTTOM字样的出线口朝向下方，防止水流入到摄像机内部，造成摄像机故障。
F. Wall-mounted Installation/ 壁装
Other than the installation location, the wall- and ceiling-mounted installation processes are the same.
墙壁安装与吊顶安装方法类似 ，区别点在于吊顶安装的摄像机安装在吊顶上。
1
Confirm that the cable outlet on the wall is large enough for the pigtails to pass through. Affix the drilling
sticker to the camera installation position and ensure that the center of the sticker matches the cable outlet
on the wall.
检查墙壁出线孔直径， 确保尾线可以顺利穿过出线孔。 将安装定位贴纸贴在摄像机安装位置， 贴纸中心请对准墙壁出线孔。
5
Advertisement
