Advertisement
Device Installation/ 设备安装
C. Beam-mounted Installation (With Junction Box)/ 横臂（带接线盒）
Place the junction box on the mounting bracket such that the arrows on each of them are aligned. Then use
1
M4 screws to mount the junction box onto the mounting bracket.
将接线盒上的箭头方向对准支架上的箭头方向，使用十字螺丝刀拧紧 M4 螺钉将接线盒安装到支架上。
Open up the three hose clamps and thread them through the installation holes on the mounting bracket.
3
Then use the hose clamps to affix mounting bracket to the beam.
将 3 个喉箍拧开，穿过抱装支架的安装孔。将喉箍环绕在横臂上，拧紧喉箍，将抱装支架固定在横臂上。
Clip the safety line of the junction box to the bottom of the camera. Tighten the M4 screw to fix the line in place.
2
Thread the cables through the junction box and attach them to the camera pigtails. Waterproof and insulate the
connections (for details, see Cable Connection) and fix the camera pigtails in place. Finally, tighten the M5 screws
to fix the camera in place.
先将接线盒上的防掉绳扣到摄像机底部，拧紧 M4 号螺钉固定，然后将线缆穿入到接线盒内，将线缆与摄像机尾线连接，对
线缆进行绝缘和防水处理（参见"连接线缆"），并固定尾线，最后拧紧 M5 号螺钉固定摄像机。
CAUTION/ 注意
Make sure the cable outlet (marked with BOTTOM) faces downwards or water may enter the camera and damage
the device.
摄像机底座写有BOTTOM字样的出线口朝向下方，防止水流入到摄像机内部，造成摄像机故障。
4
Loosen the three hex socket bolts and adjust the camera to the required angle. Then re-tighten the screws,
and adjust the position of the sunshield.
拧松支架的 3
个内六角螺钉，调整摄像机监控角度至所需位置，再拧紧内六角螺钉。同时调整好遮阳板位置。
NOTE/ 说明
After adjusting the angle of the camera, if you are unable to automatically or manually bring the image
into focus, use the web interface to log in to the IPC, and click the
reset the lens.
调整完毕后，在自动对焦或者手动聚焦后图像仍然模糊（由镜头失步引起的虚焦），请登录Web页面，在预览界
面，单击页面云台控制面板的复位镜头
4
icon on the PTZ control panel to
。
Advertisement
