Advertisement
Shaft Installation
1. Check the access hole in the drive unit housing to
see if the drive quill set screw (58) is accessible
(see Fig. 2).
Fig. 2
2. If the drive quill set screw is not accessible, jog the
motor to align the drive quill (35):
Installation
equipment damage, do not jog the motor with the
shaft and impeller in the drive quill.
a. Refer to the Power Connection section for
b. Supply power in short intervals, rotating the
c. Disconnect power from the motor.
3. With power disconnected, insert the top end of the
shaft into the drive quill so that the shaft contacts
the top of the quill.
4. With the shaft fully inserted into the drive quill, use
a hex key wrench to secure the set screw.
WARNING
MOVING PARTS HAZARD
Moving equipment parts can cause
injury, including amputating of hands or
fingers. To reduce risk of injury or
your motor type to connect power to motor.
drive quill until the drive quill set screw is
accessible by a hex wrench.
310500
5
Advertisement
