Replacing Carbon Brushes; Optional Accessories - Makita RP2302FC Instruction Manual

Replacing carbon brushes

Fig.33
► 1. Limit mark
Check the carbon brushes regularly.
Replace them when they wear down to the limit mark.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
1. Use a screwdriver to remove the brush holder
caps.
2. Take out the worn carbon brushes, insert the new
ones and secure the brush holder caps.
1
Fig.34
► 1. Brush holder cap
Only for model RP1803, RP1803F, RP2303FC
After replacing brushes, plug in the tool and break in
brushes by running tool with no load for about 10 min-
utes. Then check the tool while running and electric
brake operation when releasing the switch trigger.
If electric brake is not working well, ask your local
Makita service center for repair.
OPTIONAL
ACCESSORIES
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
1
Center.
•
•
•
•
•
•
•
•
•
•
•
•
•
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
13 ENGLISH
CAUTION:
These accessories or attachments
Straight & groove forming bits
Edge forming bits
Laminate trimming bits
Straight guide
Trimmer guide
Guide holder
Templet guides
Templet guide adapter
Lock nut
Collet cone
Collet sleeve
Wrench
Dust nozzle set