Removing And Attaching The Accessory Connector Cover - Motorola APX 6000 User Manual

Removing and Attaching the Accessory
Connector Cover
The accessory connector is located on the antenna
side of the radio. It is used to connect accessories to
the radio.
Note: To prevent damage to the connector, shield it
with the connector cover when not in use.
1 To remove the accessory connector cover, rotate
the thumbscrew
disengages from the radio.
Note: If the thumbscrew is too tight, use an Allen
wrench at
20
English
counterclockwise until it
to loosen it first.
A
B
C
2 Rotate and lift the connector cover to disengage it
from the radio.
3 To attach the accessory connector cover, insert
the hooked end of the cover into the slot above
the connector.
4 Press downward on the cover's top to seat it in the
slot.
5 Once in place, tighten by rotating the thumbscrew
clockwise by hand.