Brake Assembly - Hydro-Gear ZT-3600 Service And Repair Manual

BRAKE ASSEMBLY (Code 1 or 2) (ZT-2800
Character #7 in the model number code = 1
or 2.
Example: ZX-XXXX-1XXX-XXXX
Refer to Figure 29
Disassembly
1. Remove the center section per detail on
page 31.
NOTE: Take note of the orientation of the brake
cam (101) and the brake puck (100).
2. Remove the brake (cam) shaft (101) and
the brake puck (100).
3. Remove the O-rings (10) from the brake
(cam) shaft (101) and discard.
Inspection
1. Inspect all components for unusual wear or
damage.
34
100
101
10
Figure 29, Brake Cam Kit
/ZT-3100
®
Assembly
1. Install the new O-rings (10) onto the brake
(cam) shaft (101).
NOTE: Apply a thin coating of oil to the O-rings
before installing.
To protect the O-rings from possible
damage during installation, apply a
protective covering over the splines of
the brake cam (e.g., cellophane, tape,
etc.).
2. Place the brake puck (100) onto the brake
(cam) shaft (101). Install the brake cam kit
(208) in center section.
Center Section
10
ZT-2800
)
®
/ZT-3100 /ZT-3200 /ZT-3400
® ® TM ®