Filter And Filter Guard - Hydro-Gear ZT-3600 Service And Repair Manual

FILTER AND FILTER GUARD

Refer to Figure 4
Disassembly
1. Remove the hex head screws (105), and
filter guard (106).
2. Remove the filter (23) and discard.
NOTE: Always replace the filter when perform-
ing any internal maintenance to the
transaxle.
3. Remove the metal oil drain plug (5) or the
fitting (111) from inlet port and allow any
remaining oil to drain from the transaxle.
Inspection
1. Inspect all parts for excessive wear or dam-
age. Replace if necessary.
111
Drain port
(for horizontal installation)
When refilling the transaxle with oil,
remove the port plug (5), if installed,
and plug (11). Fill until the oil reaches the
lower lip of port (11) on side cover.
10
Units will have installed, the fitting (111)
or the plug (5).
11
Figure 4, Filter and Guard
Assembly
1. Reassemble all parts in the reverse order
of disassembly.
2. When tightening the fasteners, refer to the
table on page 22 for the required torque
values.
3. Fill transaxle with oil. Refer to "Fluid Change
Procedures," page 11, steps 3 and 4 for filter
change instructions.
NOTE: As a general rule, use the low end of
the torque specification on fasteners
when reassembling the unit.
5
ZT-2800
23
106
105
/ZT-3100 /ZT-3200 /ZT-3400
® ® TM ®