Bypass Arm - Hydro-Gear ZT-3600 Service And Repair Manual

BYPASS ARM

Refer to Figure 25
Disassembly
1. Requires removal of all items beginning on
page 14.
2. Remove the push-on retaining ring (35) and
discard. Remove the bypass arm (34).
3. Remove the retaining ring (33).
4. Remove the bypass rod (32) and the clip
retaining ring (31) as a single item.
NOTE: It is not necessary to remove the clip
retaining ring (31) from the bypass rod
(32) unless it is damaged or worn.
5. Remove the lip seal (30) and discard.
Inspection
1. Inspect the bypass rod (32) for wear or dam-
age. Replace if necessary.
NOTE: Take care to insure that the bypass rod
is free of burrs that may cut the rubber
lip seal.
ZT-2800 /ZT-3100 /ZT-3200
® ®
/ZT-3400
TM ®
Assembly
1. Install a new lip seal (30).
2. Install the clip retaining ring (31) and bypass
rod (32).
3. Install the retaining ring (33).
4. Install the bypass arm (34) and new push-on
retaining ring (35).
35
33
32
30
Figure 25, Bypass Arm
34
31
31