Table of Contents
Advertisement
Advanced OSD Controls without video input
If no video signal is available, the display enters the power save mode and the OSD cannot be displayed.
In this case, please follow the procedure below.
1. Confi rm that the display is in power save mode and the LED next to the power switch is lit orange. If the LED is off, please
push the power switch to turn on the monitor.
2. Hold down the (+) plus button and the (-) minus button simultaneously for over 2 seconds.
The "INFORMATION" OSD menu opens on the screen. The LED color changes from Orange to Green.
3. Switch EDID, Display Mode or Confi guration referring to this manual.
How to Change the EDID settings (see page 12)
How to Change the Display Mode (see page 13)
How to Change Confi guration (see page 14)
4. If the display enters the power save mode during the change process, please start from the beginning again.
Attaching a wall mount or multi-display mounting arm
The tilt and swivel stand, as shipped with the display, is interchangeable with commercially available wall mounts or multi-display
mounting arms that:
•
Come with a mount plate with 4 slotted screw holes at 100 mm x 100 mm and
•
Can bear the total weight of the LCD panel (without the stand) and the cables connected to it.
For more information ask your mounting arm supplier.
Note: Use the original screws to use the LCD panel back on its original tilt stand.
Choose the screw size carefully according to the mount plate thickness.
If the screws are too long, they could damage the internal parts. If they are
too short, the connection becomes loose and the display could fall out.
How to attach wall mounts or multi-display mounting arms
1. Place a soft cloth or cushioning material over a stable even surface.
2. Put the display face down on the soft cloth or cushioning material.
3. Remove 4 screws and detach the tilt and swivel stand shipped with the display.
4. Attach the wall mount or multi-display mounting arm according to the
manufacturer's instructions.
CAUTION
English-15
Mounting plate thickness
Screw size
1.5-4.0mm
ISO M4x16
Advertisement
Table of Contents
