Advertisement
PROFESSION L UDIO MIXER
Rear Panel Controls
Rear Panel Controls
1
4
AC INPUT
220V 60Hz, 25W
R
FUSE
MONO OUT
0.4A / 250V
4
5
1.
UX RETURN J CKS
These are stereo type phone jacks. Usually the output from effects units such as delay and reverb are
returned to the main stereo mix via these jacks. However, you can use these as auxiliary inputs.
2.
UX SEND J CKS
These are final output of UX and connected unbalanced phone jacks.
3. MIC IN
These XLR type connectors be connected with microphone. (Pin assignment 1: GND, 2: HOT, 3: COLD)
Impedance range is 50
These the phantom power switch ON to apply +48V DC to pin 2 and 3 of these connectors.
4.
C POWER ENTRY MODULE
n inlet socket to connect the power cable and fuse holder.
Please make sure the value of fuse before replacing.
5. MONO OUTPUT
This is XLR type connector used to connect a power amplifier. (Pin assignment– 1: GND, 2: HOT, 3:
COLD)
6. STEREO L/R OUTPUT
These are XLR type connectors used to connect a stereo power amplifier.
(Pin assignment– 1: GND, 2: HOT, 3: COLD)
7. LINE IN
These are balanced input connector which can be connected line level equipment.
Impedance is 10k .
6
MX-1243
2
AUX SEND
3
2
1
12
11
10
L/MONO 2
R
L/MONO 1
AUX RETURN
12
11
10
R
L
MAIN OUT
6
to 600 .
3
MIC IN
9
8
7
6
5
LINE IN
9
8
7
6
5
7
correct capacity of fuse should be applied.
4
3
2
1
4
3
2
1
Advertisement
