Table of Contents
Advertisement
Bale Compression
The plunger (10) moves the charge flake back and compresses it against the bale
to be formed in the bale chamber (11). Both bale chamber side doors (12) and
top door (13) are hinged and can move under the action of two density cylinders
(14). This is to modify the outlet section of the bale chamber and thus to control
the density of the bales produced. An electronic system measures the load on
the plunger when you push material rearwards. The electronic system will
control the hydraulic bale density system until the load measured is the same as
the density value pre-set by the operator. That value must be chosen in relation
to the nature and to the moisture content of the crop to be baled, as well as the
bale density required.
16
Advertisement
Table of Contents
