MSI KT4M Manual page 48

1st/2nd/3rd Boot Device
The items allow you to set the sequence of boot devices where BIOS attempts
to load the disk operating system. The settings are:
Floppy
LS120
HDD-0
SCSI
CDROM
HDD-1
HDD-2
HDD-3
ZIP100
USB-FDD
USB-ZIP
USB-CDROM The system will boot from the CD-ROM at USB ports.
USB-HDD
LAN
Disabled
MSI Reminds You...
Available settings for "1st/2nd/3rd Boot Device" vary depend-
ing on the bootable devices you have installed. For example, if
you did not install a floppy drive, the setting "Floppy" does not
show up.
Boot Other Devices
Setting the option to Enabled allows the system to try to boot from other
devices if the system fails to boot from the 1st/2nd/3rd boot device.
Swap Floppy
Setting to Enabled will swap floppy drives A: and B:.
Seek Floppy
This setting causes the BIOS to search for floppy disk drives at boot time.
When enabled, the BIOS will activate the floppy disk drives during the boot
process: the drive activity light will come on and the head will move back and
forth once. First A: will be done and then B: if it exists. Setting options:
Disabled, Enabled.
The system will boot from floppy drive.
The system will boot from LS-120 drive.
The system will boot from the first HDD.
The system will boot from the SCSI.
The system will boot from the CD-ROM.
The system will boot from the second HDD.
The system will boot from the third HDD.
The system will boot from the fourth HDD.
The system will boot from ATAPI ZIP drive.
The system will boot from the floppy drive at USB ports.
The system will boot from the ZIP drive at USB ports.
The system will boot from the HDD at USB ports.
The system will boot from the Network drive.
Disable this sequence.
BIOS Setup
3-9