Husqvarna BS 75 Operator's Manual page 8

Grounded product instructions
WARNING:
result in electrical shock. Speak to an
approved electrician if you are not sure if
your mains outlet is correctly grounded.
Do not do modifications to the power plug
from its factory specification. If the power
plug or power cord is damaged or must be
replaced, speak to your Husqvarna service
agent. Obey local regulations and laws.
If you do not fully understand the
instructions about the grounded product,
speak to an approved electrician.
Use only grounded outdoor extension cables with
grounding plugs and grounding outlet that accepts the
product power plug.
The product has a grounded power cord and power
plug. Always connect the product to a grounded mains
outlet. This decreases the risk of electrical shock.
Do not use electrical adapters with the product.
Extension cables
• Use only approved extension cables with sufficient
length.
• The rated value on the extension cable must be the
same or higher than given on the rating plate of the
product.
• Use grounded extension cables.
• When you operate the product outdoors, use
an extension cable that is applicable for outdoor
operation. This decreases the risk of electrical
shock.
• Keep the connection to the extension cable dry and
off the ground.
• Keep the extension cable away from heat, oil, sharp
edges or moving parts. A damaged cable increases
the risk of electrical shock.
• Make sure that the extension cable is in good
condition and not damaged.
• Do not use the extension cable while it is wound up.
This can cause the extension cable to become too
hot.
• Make sure that the extension cable is behind you
and the product when you use the product. This
prevents damage to the extension cable.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
• Do not use a product with safety devices that are
damaged or do not operate correctly.
8
Incorrect connection can
Read the warning
• Do a check of the safety devices regularly. If the
safety devices are damaged or do not operate
correctly, speak to your Husqvarna service agent.
• Do not make modifications to safety devices.
ON/OFF switch
The ON/OFF switch is used to start and stop the power
supply to the product.
To do a check of the start/stop and function selection
switch
1. Set the start/stop and function selection switch to
"0".
2. Connect the product to the power supply.
3. Set the start/stop and function selection switch to
"1".
4. Push the forward drive lever. The drive motor starts.
5. Set the start/stop and function selection switch to
"2". The drive motor is on and the vibration motor
starts.
6. Set the start/stop and function selection switch to
"0".
7. Make sure that the drive motor and the vibration
motor stops.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
• Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
• Be careful when you replace the blade, it is very
sharp. Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
• Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Clean the product to remove dangerous material
before you do the maintenance.
• Remove the blade before you do the maintenance.
• Before you do the maintenance, stop the motor and
disconnect the power plug.
• Do the maintenance of the product on stable level
ground.
• Do not do modifications to the product. Modifications
that are not approved by the manufacturer can
cause serious injury or death.
• Replace damaged, worn or broken parts.
• Always use original accessories and spare parts.
Accessories and spare parts that are not approved
Read the warning
1804 - 003 - 28.08.2023