KMC Controls 30 Series Operator's Manual page 6

1. Open all shields and check chains and belts for proper
tension.
2. Check setscrews and jam nuts on all sprockets,
sheaves, shafts, etc. for proper torque.
3. Check oil level in gear boxes, remove the level plug on
rear face of gear box. Oil should just reach bottom of
hole. Add high grade SAE 90 weight oil if necessary.
4. Check all lubrication points (see chart on page 14) and
lubricate accordingly.
5. Check airlift duct at bottom for proper alignment with
hopper.
6. Connect tongue to tractor (see page 6 for instructions)
then connect hydraulic lines for tank and header.
Slowly raise and lower the tank and header to work all
air out of lines. Check lines for leaks and correct if
necessary.
4
PRE-OPERATION CHECKLIST
7. Install tractor PTO driveline, be sure distance from end
of PTO to drawbar hole is correct. Operate combine at
1/2 speed for 5 minutes. Stop combine and check for
loose bolts, nuts, chains, belts, sprockets, etc. and for
hot bearings and gear box.
8. Make any necessary corrections and run again at full
speed for 10 minutes and check all items again.
9. Check tire pressure and set at 32 PSI. Also check lug
nuts for proper torque.
10. Set delivery duct air damper fully open (linkage in top
bottom hole.)
11. Disengage all strippers before going to the field. Strip-
per handles are labeled to show the IN and OUT posi-
tions.
CAUTION: Never check for leaks with
bare hands as small oil leaks under pres-
sure can penetrate skin and cause serious
injury.
DO NOT GO NEAR LEAKS
•
High pressure oil easily punc-
tures skin causing serious injury,
gangrene or death.
•
If injured, seek emergency medi-
cal help. Immediate surgery is
required to remove oil.
•
Do not use finger or skin to