HP 8559A Operation And Service Manual page 15

GENERAL INFORMATION
TABLE 1-2. MODEL8559A/180-SERIES SUPPLEMENTAL CHARACTERISTICS (2 OF 3)
NOTE: Values in this table are not specifications. They are typical characteristics
included for user information.
Third Order Intermodulation Distortion
-30 dBm 50 kHz
Signal Identifier
Signal identifier provided over entire frequency
range and in all Frequency Span/Div settings.
Correct signal response is a 1 MHz shift to the
left and approximately a 6 dB lower amplitude.
SWEEP CHARACTERISTICS
MANUAL SWEEP
Spectrum analyzer may be swept manually, in either
direction, with front panel control.
SWEEP TRIGGER
Free Run
End of each sweep triggers new sweep.
Line
Sweep triggered at ac line frequency.
Video
Sweep triggered on post-detection video wave-
form. One-half major division of vertical deflec-
tion required to trigger sweep.
Single
Single sweep started or reset by turning SWEEP
TRIGGER clockwise momentarily.
FRONT PANEL INPUT AND OUTPUT
CHARACTERISTICS
SIGNAL INPUT
lnput Impedance
50 ohms nominal; Precision Type N female
connector.
SUPPLEMENTAL CHARACTERISTICS
lnput SWR
<2.0 SWR with 0 dB input attenuation
<1.3 SWR with r 10 dB input attenuation
Relative
Disortion
LO Emission (3.0
VERTICAL,
HORIZONTAL OUTPUTS (AUX A, B, D)
These outputs are compatible with and may be
used to drive H P X-Y Recorders (using positive
pencoils or TTL penlift input) and CRT moni-
tors.
AUX A VERTICAL OUTPUT
BNC output provides detected video signal from
a 50-ohm output impedance. Typical 0
range corresponds to full 8-division CRT vertical
deflection.
AUX B PENLIFT/BLANKING OUTPUT
BNC output provides a + 15V penlift/blanking
signal from a 10K-ohm output impedance when
CRT trace is blanked. Otherwise, output is low
at O V (low impedance, 150 mA max.) for an
unblanked trace.
'Rear panel outputs refer to 180T-series display main-
frames and other 180-series mainframes with Option 807
installed. Horizontal, vertical, and blanking outputs,
attenuated and shifted in dc level, are available on other
180-series mainframes at the MAIN SWEEP, MAIN
GATE, and DELAYED GATE outputs, respectively. DO
NOT connect an X-Y recorder to the DELAYED GATE
OUTPUT, or damage will result.
6.1 GHz)
-
8 dBm with 0 dB input attenuation
-
REAR PANEL OUTPUT
CHARACTERISTICS'
PENLIFTIBLANKING,
MODEL 8559A
AND
800 mV
-