Drink Counts; Advanced Blend Cycle Control - K-Tec BLENDTEC BDI Owner's Manual

7.7.4.8 The screen now reads, "New Acode:". Enter the new one to four
7.7.4.9 The screen then reads, "Re-Enter:" Re-enter the desired code and
7.7.4.10 Press the STOP button twice to exit the menu.
7.8

Drink Counts:

The following options allow the user to maintain counts of the individual drinks
made by day and total for lifespan.
7.8.1 Total Machine Count:
To access the machine count press 8-0-0-GO. The machine count will be
displayed. If the number of cycles has exceeded 65,535 cycles then there
will be a multiplying counter that is displayed also. The multiplying
counter will increment each time the machine count reaches 65,535 and
resets to 0. To exit the machine count screen press STOP twice. This
count cannot be reset.
7.8.2 Individual Drink Counts:
Each time a Drink Cycle is run a respective count will be incremented.
This count can be viewed by pressing 8-0-1-GO. The screen will read,
"Drink # 1 ____". Use the M button to increment the Drink number and
use the S button to decrement the Drink number. These counts can be
cleared by using the 8-0-3-GO feature.
7.8.3 Total Drink Count:
A total of all of the individual drinks can be viewed by pressing 8-0-2-GO.
This total count is reset to zero when the 8-0-3-GO feature is executed.
7.8.4 Clear Drink Count:
By pressing 8-0-3-GO, all of the individual drink counts are cleared as
well as the Total Drink Count. After pressing 8-0-3-GO, the screen reads,
"Clear Counts?". Press GO to confirm that the Counts should be cleared.
7.9

Advanced Blend Cycle Control

This feature allows the user to customize up to 10 blend cycles.
7.9.1 Press 7-9-0-GO to access the Blend Cycle Menu.
7.9.2 The first thing that appears on the screen is, "Cycle 1 SpeedA: 0".
7.9.3 From this point use the S, M, L, and Go buttons to navigate to any of the
parameters in the Blend Cycle. S will decrement the Blend Cycle number,
M will increment the Blend Cycle number, L will advance through the
speed/time parameters in the reverse direction, and Go will advance
through the speed/time parameters in the forward direction.
7.9.4 Enter the speed for SpeedA. (Speeds start at 1 and continue through 9
with 9 being the most aggressive.) Press GO to store the value.
7.9.5 The data set will change to TimeA. Enter the time in whole seconds that
you want the blender to run the speed and press GO.
7.9.6 Repeat the steps to input the blend speeds and times for each sub speed
and time to create a cycle to set up to your own parameters. All 10 of the
cycles can be manipulated.
7.9.7 Note – you can reduce the amount of noise coming from the blender motor
by keeping the blender speed under 7. We recommend that you only
manipulate cycles 7-10 and leave the default cycles alone.
OWN-003 Model BDI Owner's Manual – Blender Dispenser with Ice
digit code that is desired and press GO.
press GO.
20