Adjusting Product; Adjusting Water; Adjusting Ice - K-Tec BLENDTEC BDI Owner's Manual

6.1.1 Navigating in the program is done with the S, M, L and GO buttons on the
control panel.
6.1.2 The S and M buttons move you up and down in drinks; 1-64 on M and 64-
1 on S.
6.1.3 The L and GO button will move you up and down in the data sets; GO
moves forward (pump 1-8) and L moves backward (pump 8-1).
6.1.4 You must enter the programming mode before any changes can be made.
6.1.5. To exit the programming mode at any time press the STOP button twice.
6.1.6 It is possible to access a specific drink number in the Drink Settings Menu
(7-8-9-GO) by pressing a 1, then the drink number (1 to 64), and then GO.
6.2

Adjusting Product:

6.2.1 Product values can be added, removed or adjusted as you see fit; however,
when you find a drink setting that works for you it is recommended that
you do not change it unless absolutely necessary.
6.2.2 To adjust product settings, scroll to the drink number (S or M buttons) you
wish to change.
6.2.3 Now use the GO button to move to the pump number that needs to be
changed.
6.2.4 Pump values are recorded in tenths of a second. In other words, 22 on the
display represents 2.2 seconds of dispense time. You can equate one
ounce per second of dispense time.
6.2.4.1 The dispense rate will vary slightly depending on the type of
6.2.5 Enter the value you want by pressing the correct numbers on the control
panel and then the GO button.
6.2.6 The value will store and then move onto the next pump or data set.
6.2.7 To zero out a value, scroll to the appropriate pump, enter 0 on the keypad
and press GO.
6.3

Adjusting Water:

6.3.1 Scroll to the Water data set by pressing either the L or GO buttons.
6.3.2 Water is also entered in tenths of a second. Water dispense should not
vary unless your water pressure coming into the unit is less than 30psi.
6.3.3 Enter the value required by pressing the numbers on the control pad and
then pressing the GO button.
6.3.4 To zero out the water value, enter 0 on the keypad and press GO.
6.4

Adjusting Ice:

6.4.1 Scroll to the Ice data set by pressing either the L or GO buttons.
6.4.2 Ice is also entered in tenths of a second.
6.4.3 Enter the value required by pressing the numbers on the control pad and
then pressing the GO button.
6.4.4 To zero out the ice value, enter 0 on the keypad and press GO.
6.4.5 Ice dispense rate may vary depending on the type and shape of ice cube
that you utilize. See Section 7.1 for calibration instructions.
OWN-003 Model BDI Owner's Manual – Blender Dispenser with Ice
product you are using. A 4 to 1 concentrate will be thicker and
will therefore need more time to dispense. See section 7.1 for
Calibration help.
13