Basic Programming; Program Mode - K-Tec BLENDTEC BDI Owner's Manual

5.4.4.19 Once the cycle is done, the screen will read "CLEAN 3 4
5.4.4.20 Repeat to sanitize the remaining lines.
5.4.4.21 Remove the hose and connectors from the container of sanitizer.
5.4.4.22 Run each pump individually to clear the remains of the sanitizing
5.4.4.23 Retrieve the product bags from the refrigerator and reconnect.
5.4.4.24 To sanitize by using JUICE button. Follow the steps above
5.4.4.25 Once the material dispensing from the unit is clear, release the
5.4.4.26 Repeat for all eight pumps.
5.4.4.27 Follow the instructions for wash, rinse and sanitize above.
5.4.4.28 Regardless of method use, refill the product lines by pressing the
Section 6: Basic Programming_____________________________________
This section will help you with the basics of programming and allows for the
programming of drinks to your requirements. This feature will give you the opportunity
to view, and if necessary, change your data set parameters (see figure 3 for the data set
sequence).
Pmp 1 Pmp2 Pmp 3 Pmp 4 Pmp 5 Pmp 6 Pmp 7 Pmp 8 Watr Ice Stime Scycl Mtime Mcycl Ltime Lcycl Pause
Drink 1
Drink 2
Drink 64
Figure 3 – Data set sequence in programming mode.
6.1

Program Mode:

This is the mode that you will utilize to change settings for pumps, water, ice,
blend cycles and blend times and pause. To enter the mode you press 7-8-9-GO
in sequence. The display will change from "Enter Drink #" to "Drink 1 Pmp 1
00".
READY". Make sure the blender jar is empty and press GO.
Pumps 3 and 4 will run.
solution from the product lines.
EXCEPT do not use 9-8-0-GO; instead, press the button of the
product pump (1-8) and then press and hold the JUICE button.
JUICE button.
pump number (1-8) and the JUICE button until the product
dispenses, then release the JUICE button.
OWN-003 Model BDI Owner's Manual – Blender Dispenser with Ice
12