ADTRAN SFP+ Combo PON D1 OLT Quick Start

Quick Start
D
ESCRIPTION
The Combo PON Optical Line Terminal (OLT) Small Form-factor
Pluggable (SFP+) combines the 10 Gig XGS-PON OLT and
GPON OLT optical transceiver into a single-mode fiber SFP+. The
SFP+ plugs into an ADTRAN optical interface that is designed to
accept the Combo PON pluggable optics. The SFP+ provides a
single optical interface to a physical interface and provides a
9.953 Gbps XGS-PON and a 2.488 Gbps GPON interface to the
supporting system when installed into an appropriate product.
Both the XGS-PON and GPON optical burst mode receivers
incorporate APD/TIA optics for maximum sensitivity. The 
XGS-PON transmitter incorporates a 1577 nm EML laser
assembly and the GPON transmitter incorporates a 1490 nm DFB
laser assembly. It is FDA 21 CFR 1040.10 and 1040.11, and IEC
60825-1 Class I laser safety compliant and meets the EU RoHS
Directive.
This SFP+ supports the following features:
■ ODN Class D1 (N1/B+) Transceiver
■ Data rate: 9.953 Gbps and 2.488 Gbps
■ XGS-PON Optical Receive Wavelength: 1270 nm
■
XGS-PON Optical Transmit Wavelength: 1577 nm
■ GPON Optical Receive Wavelength: 1310 nm
■ GPON Optical Transmit Wavelength: 1490 nm
■ Hot Pluggable
Applications:
■ XGS-PON and GPON Access networks
■ Fiber to the Premises (FTTP)
■ Fiber to the Building (FTTB)
■
Fiber to the Curb (FTTC)
Due to compliance certification requirements, use only pluggable
optics supplied by ADTRAN. ADTRAN cannot certify system
integrity with other pluggable optics.
ADTRAN Pluggable Optics
SFP+
Combo PON D1 OLT
I
NSTALLATION
Before installing the equipment, inspect the SFP+. If damage has
occurred during shipping, file a claim with the carrier, and then
contact ADTRAN Customer Support. For more information, refer
to the warranty.
Changes or modifications not expressly approved by ADTRAN
will void the warranty.
Installation Steps
To install the SFP+ into an appropriate device, complete the
following steps:
g
NOTE
Do not remove the protective dust covers from the SFP+ until the
fiber optic cable is ready to be connected.
1. Insert the SFP+ into the SFP+ cage on the equipment or
device.
2. Slide the SFP+ all the way into the SFP+ cage until there is
an audible "click".
g
NOTE
■ Orientation of the SFP+ will vary depending on the equipment.
■ The latch on the SFP+ is for removal only. When removing the
SFP+, rotate the latch away from the SFP+. It should easily
slide out of the cage.
w
NOTICE
Do not remove the protective dust cover until the optical fiber
connection is made. Ensure that you keep the protective dust
cover on whenever the transceiver optical fiber connector is not
inserted.
3. Continue the installation and turn-up of the device or
equipment using the instructions in the Job Aid or Quick
Start provided with the equipment or device or other system-
level documentation available online at www.adtran.com.
November 2020
61442543F1-13A
P/N: 1442543F1