Table of Contents
Advertisement
Transmitter Compliance Statement
C
Adjustment 2:
Limit Switch and Force Adjustments must be completed
before checking the contact reverse function (Figure MA-3) .
A
Open garage door using
Wall Console .
B
Lay a 2" x 4" board flat in center
of doorway .
C
Close door using Wall Console .
D
Check that door stops and reverses
within 2 seconds after it
contacts board:
•
If door does not reverse, decrease
Close Force until door reverses .
•
If door still does not reverse,
move Limit Switch toward door .
E
Check Safe-T-Beam® System
operation:
•
If beam is blocked, door will
not close .
The door must contact the 2" x 4" board before the Carriage activates
the Close Limit Switch . If not, readjust the Close Limit Switch .
8
S
C
h
ettinG
ontaCt
R
f
eVeRSe
unCtion
NOTE
Figure MA-3
2" x 4" board
laid flat
NOTE
a
CCeSSoRieS
C
Programming 1:
NOTE
•
Each Remote Control must be programmed
separately .
•
The Remote Controls will not cause the door
Opener to close the garage door if the Safe-T-
Beam® System is malfunctioning .
•
When programming the Remote Controls, they
must be at least 24" from the Antenna Wire .
•
If the red Learn Indicator Light blinks
approximately 4 times per second,
programming has stopped . If programming
has stopped, repeat the above steps .
•
Each Button on a 2 or 3 Button Remote Control
is for a different Opener . You cannot use more
than one Button per Remote, per Opener .
•
A maximum of seven Remote Controls or
Wireless Keypads can be stored into the
Receiver at one time . If a Remote Control
becomes lost, or if you want to delete a Remote
Control or Wireless Keypad, see "To Erase All
Receiver Memory . "
A
To program one Button of a Remote Control (Figure MA-4):
•
Locate Learn Button and Learn Indicator Light
on left side of Power Head (Figure MA-5) .
•
Press and release Learn Button . Red Learn
Indicator Light will blink 2 times per second .
•
Press Remote Control Button once within 30
seconds . Red Learn Indicator Light will stay lit .
•
Press Remote Control Button again . Red Learn
Indicator Light will go out, indicating that
memory is stored .
B
Program each additional Remote using step A above
(up to seven) .
To Erase All Remotes from Power Head Memory
A
Press and hold Learn Button on Power Head for 10
seconds or until Learn Indicator Light goes out .
Memory is erased:
•
Program Transmitter/Receiver again as needed .
To Replace Remote Control Battery
A
FOR NON-FLASHLIGHT MODELS
•
Pop off the back of the transmitter .
–
Use coin, pen, screwdriver or any similar device .
–
Replace old Battery with new coin type battery .
•
Replace back of remote.
B
FOR FLASHLIGHT MODELS
•
Slide open battery cover .
–
Replace old Battery with new AAA battery .
•
Replace battery cover.
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
p
RoGRamminG the
R
C
emote
ontRolS
Hide quick links:
Advertisement
Table of Contents
