Table of Contents
Advertisement
3. Using the Live Mode
3.5 Manual configuration (continued)
n Automatic connection failed.
The reason is that the IP address set in the
projector is the global address.
Following the instruction by the network
administrator, set the IP address and Subnet
mask in the "Live Viewer 3".
After input these address, click [Connect].
If you want to erase the information you input, click [Reset].
NOTE
• If the IP address you input to the PC is the same as the one set in the
projector, a warning message will come up. Please choose an IP address that
is currently not in use.
n A Network Configuration Conflict exists.
The message comes up when the network
connection mode you set in the PC does not
match with the mode of the projector.
Please verify your network configuration
setting on the projector and PC.
Click [Exit], then the "Live Viewer 3" main
menu is displayed even though the network
is not established. Click
to go back to the item 3.3.3 Connecting to
the network. (31)
48
on the main menu
Advertisement
Table of Contents
