Equipment Connection And Network Setting; Required Equipment Preparation; Quick Connection - Hitachi 8953H User Manual

Table of Contents

2. Equipment connection and network setting

The following equipments are required to connect the projector to your PC through

the network.

■ Common

The projector: 1 unit,

It is recommended to install the "Live Viewer 3" into the PC.

■ Depending on how you want to connect

1) For the wired connection

LAN cable (CAT-5 or greater): 1 piece

2) For the wireless connection *2

- Projector side

The Wireless Network Card (option : VA0833x *4) : 1 unit

- PC side

IEEE802.11b/g wireless LAN equipment: 1 unit *3

*1: For the PC, please refer to the item 3.2.1 Minimum PC hardware and software

requirement. (23)

*2: An access point is required when the wireless LAN connection is used as

Infrastructure mode.

*3: Depending on the type of wireless network device and PC you are using, the

projector may not be able to communicate properly with your PC, even if the

PC you are using is equipped with built-in wireless LAN function.

To eliminate communication problems, please use a Wi-Fi certified wireless

network device.

*4: For more information, please consult your dealer.

The "Live Viewer 3" supports very quick and simple connection to the network.

It is strongly recommended to install the "Live Viewer 3" into your PC to enjoy

the feature. Proceed to the installation of the "Live Viewer 3" (23) and the

connection. (26)

In case you don't want to use the "Live Viewer 3" or you cannot use it by some

reason, proceed to the manual setting, the item 2.3 for the wired LAN (11) and

the item 2.4 for the wireless LAN. (16)

PC : 1 set *1

Table of Contents