EIP Ebac WM150 Owner's Manual page 7

The WM150 Dehumidifier can be left free standing unit, alternatively can be wall
mounted for instructions on mounting the unit please read the following:
A full installation kit is included in the package to allow a problem free install. This kit
comprises of the following:-
1 X WM150 Dehumidifier
1 X Mounting Bracket
4 X Rawl plugs and screws
4 X M6 Hex Head Bolts, flat and spring washers
For mounting the WM150 Dehumidifier to a wall you will first need to remove the cover
from the unit and detach the wall mounting bracket from the rear of the unit by
removing the 4 bolts that secures it.
With reference to the installation drawing at the rear of this manual, maintain the
minimum clearances from adjacent objects (i.e. walls ceilings etc). Maintaining these
distances will ensure easy access for installation and maintaining the unit during the
products life
Place the wall mounting bracket onto the wall, ensuring the correct orientation, and
the bracket is level. Mark off 4 points on the wall where you will be securing the
bracket, the bracket has numerous holes and slots to allow the bracket to be mounted
at different points depending on the wall you are mounting it to. It is advised to have
the fixing points spaced out as far as possible to allow a more ridged and secure
installation.
Using a 7mm masonry bit, drill the 4 points you marked off earlier to a depth of 40mm,
insert the 4 Rawl plugs into the wall that are supplied with this unit.
Secure the wall mounting bracket to the wall using the 4 brass screws supplied with
the unit.
Ensure all fixings are tight and bracket is secured to the wall.
Screw 2 X M6 Bolts into the top fixings on the bracket, only screwing them in a 2-3
turns. Lift the unit onto the bracket and hook the unit onto the bolts using the keyhole
slots in the rear of the unit do not tighten the bolts yet. Fit the 2 remaining bolts through
bottom holes in the rear of unit and into the wall mounting bracket and tighten all 4
bolts.
Check to make sure the unit is secure to the wall mounting bracket.
Replace cover and refit all fixings that have been removed.
WM150 OWNERS MANUAL
INSTALATION
Drawing No. :- TPC551
Issue :- 1
Date :- 19/05/21
Page 7 of 16