e. Remove the entire thermal sensor from the chassis.
Figure 83. Removing the thermal sensor
4. To install the new thermal sensor, do the following:
a. From the inner side of the chassis, insert the tab
chassis as shown. Then, push the thermal sensor outward until the retaining clip on the other side
snaps into position.
Figure 84. Installing the thermal sensor
b. Connect the thermal-sensor cable to the thermal-sensor connector on the system board. See "Parts
on the system board" on page 37.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
1
of the new thermal sensor into the hole in the
.
Chapter 9
Hardware removal and installation
137