Table of Contents
Advertisement
b. Place the new storage drive with the bracket into the storage drive bay as shown. Press the two tabs
on the bracket downward and then push the storage drive inward until it snaps into position.
Figure 49. Installing the 3.5-inch storage drive
c. Connect the signal cable and power cable to the new storage drive.
2.5-inch storage drive
To remove or install a 2.5-inch storage drive in the storage drive bay, do the following:
1. Prepare your computer. See "Preparing your computer" on page 92.
2. Locate the storage drive bay. See "Internal storage drives" on page 38.
3. To remove a 2.5-inch storage drive in the storage drive bay, do the following:
a. Disconnect the signal cable and the power cable from the storage drive.
.
Chapter 9
Hardware removal and installation
117
Advertisement
Table of Contents
