Set Your Ipv6 Settings - TRENDnet Web Smart Switch Series User Manual

TRENDnet User's Guide
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2023 TRENDnet. All Rights Reserved.

Set your IPv6 settings

System > L3 Feature > IPv6 Interface
Internet Protocol version 6 (IPv6) is a new IP protocol designed to replace IP version 4
(IPv4). The IPv6 address protocol meets the current requirements of new applications
and the never ending growth of the Internet. The IPv6 address space makes more
addresses available but it must be approached with careful planning. Successful
deployment of IPv6 can be achieved with existing IPv4 infrastructures. With proper
planning and design, the transition between IP version 4 and 6 is possible today as well.
Use the IPv6 Interface page to configure the IPv6 network interface, which is the logical
interface used for in-band connectivity with the switch via all of the switch's front-panel
ports. The configuration parameters associated with the switch's network interface do
not affect the configuration of the front-panel ports through which traffic is switched or
routed.
1. Log into your switch management page (see
on page 5).
2. Click on System, L3 Feature, and then IPv6 Interface.
3. To create a new entry per VLAN, type the VLAN number you would like to create,
then click Add. To view a specific VLAN ID's configuration, enter the VLAN ID into the
Interface VLAN field and then click Find.
4. To change the IPv6 IP address associated with a specific VLAN, click on Detail within
the lower table.
Web Smart Switch Series
"Access your switch management page"
14