Fitting wall spacers supplied
The wall spacers supplied must be
used in order to achieve declared en-
ergy consumption values and to pre-
vent the build-up of condensation at
high ambient temperatures. Appliance
depth is increased by approx. 15 mm
with the wall spacers fitted. If the wall
spacers are not used the functionality
of the appliance is not affected. En-
ergy consumption is only slightly in-
creased with less distance between
the appliance and the wall.
Fit the wall spacers onto the back of
the appliance on the bottom left and
right.
Limiting the opening angle of
the door
The door hinges are set at the factory
so that the door can be opened up to
115°. If the appliance door hits an adja-
cent wall when opened, for example,
the opening angle can be limited to 90°.
The door opening angle limiter
should be fitted before the appliance
is installed.
To fit the door opening angle limiter
Switch off at the wall and withdraw
the plug from the socket, or discon-
nect the mains fuse.
– remove the soft-close mechanism
Open the appliance door.
Push off right outer cover .
Installation
75