Table of Contents
Advertisement
Fitting supplied wall spacers
The wall spacers supplied must be
used in order to achieve declared en-
ergy consumption values and to pre-
vent the build-up of condensation at
high ambient temperatures. The refri-
geration appliance depth is increased
by approx. 15 mm for appliances with
wall spacers fitted.
If the wall spacers are not used, the
functionality of the refrigeration appli-
ance is not affected. Energy consump-
tion is only slightly increased with less
distance between the appliance and
the wall.
Fit the wall spacers onto the back of
the refrigeration appliance on the bot-
tom left and right.
Installing the refrigeration ap-
pliance
Risk of injury and damage due to
the refrigeration appliance tipping
over.
There is an increased risk of injury
and damage if the refrigeration appli-
ance is installed by a single person.
Two people are required for installing
the refrigeration appliance.
Risk of damage to the appliance
door caused by impact.
The appliance door could hit the wall
of the room resulting in damage to
the door.
Fit the door opening angle limiter
supplied before the refrigeration ap-
pliance is installed.
Protect the appliance door by fitting
a felt stopper, for example, to the
wall of the room.
Risk of damaging the floor.
Moving the refrigeration appliance
can cause damage to the floor.
Move the refrigeration appliance
carefully on floors that are sensitive
to scratching.
For easier installation, there are trans-
port handles on the back at the top
and transport wheels underneath the
refrigeration appliance.
Tip: The refrigeration appliance must be
empty when it is installed.
Prepare the refrigeration appliance for
installation as close as possible to its
intended installation site.
Installation
19
Advertisement
Table of Contents
