Gardner Denver EBM99M 60 Operating And Service Manual page 26

The compressor starts and stops automatically. Automatic restarting can
cause injury or death. Open, lockout and tagout main disconnect and any other
circuits before servicing the unit.
STARTING THE UNIT - Observe the following starting procedures.
Unit Cold - If the unit is a water-cooled heat exchanger model, open any manual water inlet valves wide
open. Start the unit by pressing STOP / RESET, then press RUN. Since the unit is equipped with a
minimum (65 psig, 4.5 bar) pressure discharge valve, no special procedure to maintain unit reservoir
pressure is required.
Unit Hot - No warm-up period is required. If the unit is a water-cooled heat exchanger model, open any
manual water inlet valves wide open. Start the unit by pushing STOP / RESET, then press RUN
DAILY CHECK - Refer to Section 8, "Maintenance Schedule," page 79.
STOPPING THE UNIT - Press "STOP / RESET" button. The oil reservoir will automatically blow down as
the motor stops. If the unit is a water-cooled heat exchanger type, close any manual water inlet valves.
13-21-603 Page 25