Program Selection; Cycle Counter Reset; Cartridge Holder Installation - TECHCON SYSTEMS TS6500CIM User Manual

11. PROGRAM SELECTION

Up to 10 programs can be stored in the the TS6500 Mixer.
1. Press the Set button (Fig. 4.0) to highlight the program number selection.
2. Press the (+) or (-) buttons to select desired program.
3. Press the Set button to exit.

12. CYCLE COUNTER RESET

The cycle counter can record up to 99999 mix cycles. To reset the cycle counter
follow the below instructions:
1. Press and hold Setup button for 3 seconds to enter setup mode.
2. Once the setup mode is displayed, press and hold Setup button again until
the cycle counter resets to "00000".

13. CARTRIDGE HOLDER INSTALLATION

Refer to Fig. 15.0 and 16.0
The TS6500CIM-6 is setup to mix the 6.0oz. (160ml) kit. To mix the 2.5oz (60ml)
or 8.0oz. (220ml) kit the cartridge holder needs to be re-installed at the correct
mounting locations as shown in Fig. 15.
MOUNTING LOCATION
2.5oz (60ml) KIT
MOUNTING LOCATION
6.0oz (160ml) KIT
MOUNTING LOCATION
8.0oz (220ml) KIT
Figure 15.0 Mounting Location
19