Figure 13.0 Manual Mode Screen
ACTIVATE
INJECTION
9.
SPEED CONTROL
9.1
For main cylinder
The main air cylinder drives cartridge kit up and down. The stroke speed of
the main air cylinder can be adjusted by rotating the flow control screw
(Fig. 14.0) counter clockwise to increase the speed and clockwise to
decrease the speed.
9.2
For injection rod
The injection rod air cylinder drives the injection rod up and down. The
injection speed can be adjusted by rotating the flow control screw (Fig.
14.0) counterclockwise to increase the speed and clockwise to decrease the
speed.
Note: For TS6500CIM-SMR-6 and TS6500CIM-SMR-20 models, the
injection rod flow control is shut-off from the factory. To re-activate
the injection rod, slowly turn the flow control screw counter-clockwise
until the desired speed is achieved.
MAIN AIR CYLINDER
FLOW CONTROL
INJECTION ROD FLOW
CONTROL
MODE
ACTIVATE
MOTOR
Figure 14.0 Flow Control
17
PRESSURE
ACTIVATE
MIX CYCLE
SAFE TO RUN