Peak PCAN-USB FD User Manual page 9

1. Open the CAN interface casing. Push the latches on both sides cautiously with a
slotted screwdriver.
2. Remove the circuit board.
3. Set the corresponding solder bridges on the circuit board.
4. For assembly, place the circuit board on the upper half of the housing. The
strain relief and the LED must be in the corresponding recesses.
5. Press the lower half of the housing onto the upper half of the housing until the
latches engage.
Attention! The voltage supply for external devices is not protected
separately. Therefore, turn off the computer before you connect and
disconnect CAN cables or peripheral systems. Consider that some
computers still supply the USB ports with power even when they are
turned off (standby operation).
2 Settings PCAN-USB FD
User Manual 2.1.0 © 2023 PEAK-System Technik GmbH
Circuit boards of the published hardware versions
9