Peak PCAN-USB FD User Manual page 11

1. Open the CAN interface casing. Push the latches on both sides cautiously with a
slotted screwdriver.
2. Remove the circuit board.
3. Set the corresponding solder bridges on the circuit board.
4. For assembly, place the circuit board on the upper half of the housing. The
strain relief and the LED must be in the corresponding recesses.
5. Press the lower half of the housing onto the upper half of the housing until the
latches engage.
2 Settings PCAN-USB FD
User Manual 2.1.0 © 2023 PEAK-System Technik GmbH
Circuit boards of the published hardware versions
11