Table of Contents
Advertisement
16
INSTALL THE PROTECTOR SYSTEM™ (IR BEAMS)
Whilst Chamberlain have engineered safety features into your garage door opener, we urge you to consider fitting
IR Beams to your new garage door opener. In many countries these devices are compulsory to assist in
preventing serious injury or property damage. For your own peace of mind and the safety of others please install
this inexpensive safety device.
NOTE: This accessory must be used for all
installations where the closing force as measured
on the bottom of the door is over 400N (40kgf).
After the opener has been installed and adjusted, the
Protector System™ (IR Beams) accessory can be
installed. Instructions are included with this accessory.
The Protector System™ (IR Beams) provides an
additional measure of safety against a small child
or animal being trapped under a garage door. It
uses an infra-red beam, which when broken by an
obstruction, causes a closing door to open and
prevents an open door from closing and is strongly
recommended for homeowners with young
children.
Installing and adjusting:
• Close the garage door.
• Turn the opener off.
• Install the Protector System
brackets, wires and instructions provided with the
product.
• Twist the two white (only) wires together and
terminate them into the white "safety beam" terminal.
Twist the two white/black wires together and
terminate them into the grey "safety beam" terminal.
• Ensure the trim pot on the opener is set to 0s.
• Turn the opener on.
• Allow 5 minutes for the beams to self-learn to the
unit, (do not walk through the beam during this time).
• Adjust the trim pot to the desired closing time.
NOTE: The opener will automatically detect the
Protector System
(IR Beams) when it is installed
TM
and operating for 5 minutes (during this time the
beams must remain unobstructed). The opener will
not close unless the beams are aligned.
Door may operate unexpectedly, therefore do not allow anything to stay in the path of the door.
SAFETY FIRST!
(IR Beams) using the
TM
IR Beams must be installed
to detect a 100mm high
obstacle at any point along
Red LED
MUST BE ON
IR Beam
white
white/black
wires
wires
twisted
twisted
together
together
white
Remove cover: Push cover plate up,
then lever out from the button.
9
the floor.
IR Beam
grey
Red LED
MUST BE ON
Advertisement
Table of Contents
