Removing The Optional Ps/2 Keyboard/Mouse Module; Installing The Optional Ps/2 Keyboard/Mouse Module - Dell OptiFlex 3000TC Service Manual

Steps
1. To remove the dummy metal bracket, insert a flat-head screwdriver in the hole of the bracket, push the bracket to release
the bracket, and then lift the bracket out from the system.
2. Insert the Serial module into the optional I/O module slot from the inside of the computer chassis.
3. Connect the Serial module cable to the connector on the system board.
4. Replace the two screws to secure the Serial module to the system.
Next steps
1. Install the side cover.
2. Follow the procedure in

Removing the optional PS/2 keyboard/mouse module

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
About this task
The following image indicates the location of the optional PS/2 keyboard/mouse module and provides a visual representation of
the removal procedure.
Steps
1. Remove the two (M3X3) screws that secure the PS/2 keyboard/mouse module to the computer chassis.
2. Disconnect the three PS/2 keyboard/mouse module cables from the connectors on the system board.
3. Remove the PS/2 keyboard/mouse module from the system.

Installing the optional PS/2 keyboard/mouse module

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the optional PS/2 keyboard/mouse module and provides a visual representation of
the installation procedure.
Steps
1. To remove the dummy metal bracket, insert a flat-head screwdriver in the hole of the bracket, push the bracket to release
the bracket, and then lift the bracket out from the system.
2. Insert the PS/2 keyboard/mouse module into the optional I/O module slot from the inside of the computer chassis.
3. Connect the three PS/2 keyboard/mouse module cables to the connectors on the system board.
4. Replace the two (M3X3) screws to secure the PS/2 keyboard/mouse module to the system.
Next steps
1. Install the side cover.
2. Follow the procedure in
after working inside your
before working inside your
after working inside your
computer.
computer.
computer.
Removing and installing components 27