Removing Optional Sma Module - Dell OptiPlex 3000 Tower Service Manual

Steps
1. Align the graphics card with the PCI-Express card connector on the system board.
2. Using the alignment post, connect the graphics card in the connector and press down firmly. Ensure that the card is firmly
seated.
3. Lift the pull tab to close the PCIe door.
Next steps
1. Install the side cover.
2. Follow the procedure in

Removing optional SMA module

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
About this task
The following images indicate the location of the optional SMA module and provide a visual representation of the removal
procedure.
Steps
1. Lift the pull tab to open the PCIe door.
2. Hold and remove the SMA module from its connector on the system board.
after working inside your
before working inside your
computer.
computer.
Removing and installing components 43