Advertisement
Figure 2
1. Positive battery terminal
2. Positive battery cable
3. Negative battery cable
4. Negative battery terminal
2.
Disconnect the negative-battery cable from the
terminal of the battery
3.
Disconnect the positive battery cable from the
terminal of the battery
g024429
5. Battery cover
6. Battery clamp
7. Locknut
8. Carriage bolt
(Figure
2).
(Figure
2).
3
Removing the Cargo Bed
No Parts Required
For Machines with a Manual Cargo
Bed Lift
Cargo box weight: approximately 57 kg (126 lb)
1.
Lift the latch lever on either side of the machine,
near the forward corner of the cargo bed, and
fully raise the bed
1. Latch lever
2. Prop rod
2.
Secure the cargo bed by pulling the prop rod
into the rear detent at the end of the slot located
in the left side of the machine
Note:
For machines with a bolt-on rod-support
bracket, pull the prop rod into the rear detent at
the end of the slot in the bracket.
3.
Attach the lifting equipment to the front and rear
of the cargo bed.
Note:
Raise the lifting equipment at the front of
the bed until the front of the bed is supported.
4.
Remove the hairpin cotter and washer that
secure the prop rod to the bottom of the bed
(Figure
4).
3
(Figure
3).
Figure 3
3. Detent slot
(Figure
3).
g014860
Advertisement
