Advertisement
7
Installing the Cargo Bed
No Parts Required
For Machines with a Manual Cargo
Bed Lift
1.
Rotate the cargo bed so that the hinge-bracket
assembly and prop rod are facing downward
(Figure
13).
2.
Using lifting equipment at the front and rear
of the cargo bed, raise the cargo bed, and
align it over the frame of the machine with the
hinge-bracket assembly facing rearward
13).
Figure 13
3.
Adjust the height and position of the lifting
equipment so that the short leg of the prop rod
is aligned with the detent slot at the end of the
prop rod slot in the left frame channel or prop
rod bracket
(Figure
Note:
You will have to angle the cargo bed with
the lifting equipment in order to align the prop
rod to the detent slot.
4.
Rotate the prop rod forward and insert the short
leg of the rod through the detent slot
and
Figure
14).
5.
Move the cargo bed and prop rod rearward until
the hinge-bracket assembly aligns over the rear
frame channel
(Figure
(Figure
13).
(Figure 13
14).
1. Detent slot
6.
Carefully lower the cargo bed until the holes in
the hinge brackets align with the mounting holes
for the cargo bed in the rear frame channel
(Figure
15).
7.
Secure the hinge brackets to the rear frame
channel using the previously removed 4
flanged-head bolts (3/8 x 1 inch) as shown in
Figure
15.
8.
Torque the 4 flanged-head bolts to 37 to 45 N∙m
(27 to 33 ft-lb).
g226677
1. Rear frame channel
2. Flanged-head bolt (3/8 x
1 inch)
11
Figure 14
2. Prop rod
Figure 15
3. Hinge bracket
g026402
g226636
Advertisement
