Remote Control - Projecta PW500 Instructions Manual

Input Voltage
The input voltage limits are shown in the following table.
Operating Condition
Normal
Peak Performance
Low Voltage Alarm
Low Voltage Shutdown
Over Voltage Shutdown
Unit Restarts After Low Voltage
Shutdown

REMOTE CONTROL

An optional remote can be purchased for the PW500, PW1100, PW1600, PW2100 and PW2700:
P/No. PWREMOTE-1.
To install the remote control, insert the plug into the remote input socket on the rear panel.
The remote has the ability to turn the inverter on and off remotely and indicate when the inverter is on.
UNDERSTANDING YOUR POWER REQUIREMENTS
POWER REQUIREMENTS OF YOUR APPLIANCE/S:
All appliances have a rating plate that shows the amount of power (Watts) used or the current (Amps)
drawn under normal use.
The following table shows the maximum combined AC Watts or AC Amps which can be run by the inverter.
P/No.
AC Combined
maximum load
(Watts)
AC Combined
maximum load
(Amps)
Some appliances that use an electric motor or transformer may draw up to 10 times their power rating
when first turned on. These are called inductive loads and are the most difficult for the inverter to run.
Contact your appliance manufacturer for further advice.
PW500 PW1100
600W 1320W
2.5A 5.5A
Voltage Range
11.0V – 14.50V
13.0V±0.2V
10.5±0.3V
9.9±0.3V
15.2V (±0.3V)
12±0.3V
PW1600
1920W
8.00A
Comments
–
–
The audible low battery alarm
sounds.
The unit shuts down to protect the
battery from being over-discharged.
The unit shuts down to protect
itself from excessive input voltage.
NOTE: Although this incorporates
over-voltage protection, it can still
be damaged if input voltage
exceeds 15.5V.
The unit will not restart unless the
battery voltage is acceptable for
running the load.
PW2100
2520W
10.50A
PW2700
3240W
13.50A
9