Table of Contents
Advertisement
16 COOLING SYSTEM
16.6
94
F00870-10
F00855-11
Changing the coolant
Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
–
Do not open the radiator, the radiator hoses or other cooling system components if the engine or the
cooling system are at operating temperature.
–
Allow the cooling system and the engine to cool down before you open the radiator, the radiator hoses
or other components of the cooling system.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
–
2
Loosen bleeder screw
Guideline
3 turns
–
Tilt the vehicle slightly to the right.
–
Pour in the coolant until it emerges without bubbles at the
bleeder screw, and then mount and tighten the bleeder screw
immediately.
Coolant (
p. 117)
–
Completely fill the radiator with coolant. Mount the radiator
cap.
–
Rest the vehicle on the side stand.
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and allow it to warm up.
–
Stop the engine and allow it to cool down.
–
When the engine is cool, check the coolant level in the radiator
and, if necessary, add coolant.
–
3
Remove cap
of the compensating tank and top up the
coolant level to the upper marking.
–
Mount the cap of the compensating tank.
Finishing work
–
Fit the front spoiler. (
p. 65)
.
Advertisement
Table of Contents
